Aurora-audio GTP8 Manuel d'utilisateur télécharger pdf

AURORA AUDIO INTERNATIONAL

1520 NORTH CAHUENGA BOULEVARD

HOLLYWOOD, CA90028

EMAIL: Info@auroraaudio.net Telephone: 323 462 6136

Web Site: http://www.auroraaudio.net Fax : 323 462 6137

GTP8 Instruction Sheet

Introduction:

Well done for purchasing a hand-built, all discrete class A circuitry GTP8 eight channel microphone

pre-amplifier! It is designed to give you years of superb sounds and service.

Unpacking Instructions:

Carefully remove the unit and power supply from the custom foam packing. The power supply

automatically senses your local power voltage and can work between 85v and 265v. For best noise

performance always use a grounded 3 core / 3 pin a.c. cord.

If you connect the GTP8 to an unbalanced destination, wire to the XLR pins 2 and 3 only. Leave pin 1

high. This will help prevent ground loops.

The rear jack sockets are an unbalanced insertion at around -15dBu level.

Operating Guide:

The GTP8 can accommodate any signal you care to throw at it, including high-level line inputs. The

sensitivity switch provides gain adjustment in 10dB steps from +80dB to –10dB and the +/- 5dB level

pot allows for fine adjustments of level and also extends the gain range from +85dB down to -15dB.

The GTP8 does not have an output fader as it is anticipated to be used with the channel fader either in

the GTM822 console or the digital workstation the unit is connected to.

It is possible to fit an external fader to the GTP8 by using the rear panel channel insertion jacks. A

10Kohm audio taper fader could be connected as follows :-

Fader top = tip

Fader wiper = ring

Fader bottom = sleeve

The channel insertion jacks are intended to be used with our 8 channel 4 band Equalizer and is not

suitable for connecting to an external patch bay.

1 2 3

AURORA AUDIO INTERNATIONAL 1

Résumé du contenu

Page 1 - AURORA AUDIO INTERNATIONAL

AURORA AUDIO INTERNATIONAL 1520 NORTH CAHUENGA BOULEVARDHOLLYWOOD, CA90028 EMAIL: [email protected] Telephone: 323 462

Page 2

The D.I. input has 10 Megohm input impedance and around 10dB gain. It can be used (to great effect) with musical instrument pickups, but works equally

Page 3

Depending on the reference level recommendations of the A to D manufacturer, the analogue levels on its input should be typically around –18dBf. This

Commentaires sur ces manuels

Pas de commentaire

Aurora-audio GTP8 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Panneau de contrôle Aurora-audio GTP8. Aurora Audio GTP8 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle Aurora-audio GTP8